The P12 PWM PST A-RGB has 12 digital A-RGB LEDs in the fan hub. These can be controlled independently of each other and are compatible with the common A-RGB standards of leading motherboard manufacturers. The fan can thus be fully illuminated directly via the A-RGB mainboard connector or via an external controller and synchronised with the illumination of other hardware.
The speed of the fan can be throttled down to standstill via PWM. This allows silent operation in IDLE and at the same time guarantees maximum performance when required.
The operating noise of the newly developed ARCTIC motor is barely perceptible even at the lowest speed. In addition, the P12 PWM PST A-RGB has rubberised contact surfaces and thus reduces audible vibrations to a minimum.
The P12 PWM PST A-RGB operates with a focused airflow and a high static pressure. The fan thus guarantees extremely efficient cooling, even with increased air resistance, and is therefore suitable for use on heat sinks, radiators and filters.
With a wide speed range and the innovative PWM Sharing Technology (PST), the fan speed of the P12 PWM PST A-RGB can be controlled synchronously with all other fans. This reduces noise to a minimum while guaranteeing maximum cooling performance.
Thanks to an alloy/lubricant combination developed in Germany, friction within the bearing is reduced and greater efficiency is achieved. In this way, less heat develops, less bearing noise is generated and the service life of the fan is extended.

Technical Data:
Dimensions: 120 x 120 x 25 mm
Nominal speed: ca. 200 - 2,000 rpm (0 rpm below 5% PWM)
Rated current 12 V DC: 0.11 A
Rated current 5 V DC (RGB): 0.4 A
Air flow: 82.9 m³/h / 48.8 CFM
Static pressure: 1.85 mm H2O
Noise level: 0.3 Sone
Cable lenght: ca. 45 cm
Plug: 4-Pin Molex
Bearing: Fluid Dynamic Bearing

Accessory:
Four mounting screws